Adjust the time available
By the time
reverse variation of the lots available ink, ink dots variation of the
lot, lot no rub ink cartridge when the voice communication network of
pipes and other impacts that the system will change lots of ink
cartridge storage by cycle. Usually difficult to recognize this change but for those in sensitive products will be affected. Typically in the form of articles:
Thick layer of ink is not uniform among regions on the same sheet in.
Change the time available is a solution for this case, move the affected area out of sensitivity in the journal
Structural adjustment
CP2000 adjustments
Round display
Functions available to change the time and amplitude
automatically made available on the center console, the CP2000
interface is optional functions of the printer. We must pay more to buy a new function of this automatically. Below describes the structure and how to adjust the time
available on the printer does not have the option to change the time
available and ready amplitude automatically.
Transmission by the printer will pull out the disk when running back
machine. On this disc coupling with a knife hand blow to the lot ready
for ink. Fixed position joints related to the time variation of the dimensional changes lots available ink. Each ring corresponds to rewind machine in a sheet and corresponding one-dimensional variation on the lot ready ink.
Round display on the disk divided into two parts: the black arrows are (1) and section white arrows (2). Each section is numbered from 0 to 710, and corresponds to a round tua machine
How to adjust:
Structural adjustment
Click the computer until the circle of hand blow (1) to lowest position.
Recorded current values on the next show.
Loosen estate courses (2).
Click to machines - will be moved to the dark side sheet in the tail.
Click your back - will be moved to the dark side in sheets tweezers.
After setting the desired location, the right key buildings (2).
Eg
Time available are the white value 0.
Ready to change the time value of 200 parts white.
Dark region moves toward the tail sheet in about 200mm
Note:
Correlation between the value of the ring and show the location on the
sheet in the dark depends on the characteristics of each product in
particular. So when adjusting the time available to monitor specific effects on the sheets are in.
